Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Hot Saws
Chain Sharpening
I can square grind with my round grinder
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Square Cutter" data-source="post: 7896545" data-attributes="member: 183964"><p>The USG might work. I'd like to test one to see if it does. I think the front to back adjustment on the USG may work similar to the 10-degree adjustment on the Oregon 410-120. The farther away from the wheel the sharper the inside side plate angle. However, too far away from the wheel would put the wheel into the tie strap. It just depends on if the front to back adjustment on the USG would allow the entire wheel to be utilize throughout the life of the wheel. If it's off by a small amount it may not utilize a new wheel. Moving this adjustment forward will keep the cutters at the correct distance from the wheel as the diameter becomes smaller from dressing.</p></blockquote><p></p>
[QUOTE="Square Cutter, post: 7896545, member: 183964"] The USG might work. I'd like to test one to see if it does. I think the front to back adjustment on the USG may work similar to the 10-degree adjustment on the Oregon 410-120. The farther away from the wheel the sharper the inside side plate angle. However, too far away from the wheel would put the wheel into the tie strap. It just depends on if the front to back adjustment on the USG would allow the entire wheel to be utilize throughout the life of the wheel. If it's off by a small amount it may not utilize a new wheel. Moving this adjustment forward will keep the cutters at the correct distance from the wheel as the diameter becomes smaller from dressing. [/QUOTE]
Insert quotes…
Verification
Post reply
Top