Thread: Need Help reassembling a Dolmar 119 starter Pawls

Hi, I am new here and hope that i am posting this in the right place. I have just finished a complete rebuild of a Early 80's Dolmar 119. It ran for a few seconds which is good. However both starter pawls/ratchets were forced into the outer flywheel fins and damaged about 4 fins. I can't figure out any other way to configure the Pawls so that this does not happen. Does anyone have a picture of a properly assembled flywheel and starter pawls for this saw? i have spent Hours on Google and have come up with nothing. Any help or thoughts would be greatly appreciated.

Thanks

we know saws , but you'll get help in the chainsaw section faster. good luck.

Thanks, apparently I need help learning how to use this site also. I appreciate the help.