Is my saw still running a single ring? How about the cage in the carb?
I assume my saw is still running a popup piston, standard porting, no epoxy, and some timing advance.
What kind of mods to the JMS saw?
It's just a ported saw with a popup.
Its got a different muffler on it for sure and it sounds off by a good bit but honestly none of that matters,it wouldn't matter if my or yours was 50 times stronger,they still loose.
A high exhaust short bar 394 I did was smack on his 661 with a 42" 404 in CT and a bunch of people ran both and everyone said they were about even,that 394 and this 661 were at my shop at the same time and the 661 was a good ways ahead of the 394 that was basically even with his 661 that's made to run that bar.
50 people seen it and a bunch ran both saws and there's videos of it.
It would stand to reason that the 661 he's got that I ported that's stronger than the 394 that's very close to his 661 would put the 2 saws a out even but at his place with nobody to see it gets beat bad.
How does that work exactly?
It's the most chicken **** and desperate thing I've seen.
There's 10 videos of that 661 beating the 394 that 10 people ran that day and all said it's pretty well even with his 661 but not when nobody is looking. Lol
A random saw I built for a 24" bar is right with the saw That's been built and tested forever to run that 42" bar by the best saw builder in the world and he's been working on it forever.
I guess I'd be desperate to prove it's better to but I'd have the decency to tell the guys involved.
A guy that hates me beats one of my saws at his house and posts a thread about it
I feel dirty and a lesser man for even posting.
