Search results

They look and sound cool with that wide open MM.But I think you sacrifice power going that route.I leave the baffles alone and only open the outside of the muffler.Ive measured a lot of baffles and have them to be around 80 percent so I don’t mess with them .The outlet is usually where the...

The carburetors on those old saws are very sensitive but if you get the metering needle right on them they start just fine.

Sounds like it’s flooded.when I have one thats badly flooded I take a plug out of a saw that’s been run for a few minutes and put it in the flooded saw.and give it a try.sometimes a nice hot plug in a flooded saw does the trick.The crank case may have too much fuel in the bottom.To remedy this...

Finding a stray circlip on the bench after you put the top end together:)

When you start it for the first time :happybanana:

I have 2 50s and 2 55 close ports,They don’t make em like that any more:)

Better check the carb to see if the screws are in the butterfly’s :)

The collar your spring goes into looks like the problem.the black part looks distorted.

Thanks:)

Does anyone know where or what I could use for a coil for a 2800 poulan?

They like a timing advance:)

Every thing they said oh and don’t forget to rinse out the crank case thoroughly.I use fuel mix and do it several times to make sure it’s clean.

How much total,shipped to 33634

Is this still for sale?

Here ya go:)

The fuel lines don’t look like their connected in the right configuration.you might want to google how they’re supposed to be connected.:)

Those are the same specs as a 55 Husqvarna, stock hp for them is 3.3