Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. J

    Sold Stihl ms 361 with R kit

    Sent you a PM about saw.
  2. J

    super clean early 066

    PM sent.
  3. J

    Stihl 036 Pro limiter cap removal

    Ended up just pulling on the limiters with a pair of pliers, they came right off! Didn't have to remove the block as they were apparently just pressed in with no retaining shoulders.
  4. J

    Stihl 036 Pro limiter cap removal

    Sounds like the best course of action!
  5. J

    Stihl 036 Pro limiter cap removal

    I'll give some of this a try and see what happens. If nothing else I'll run it to the dealer and have them get the darned things off!
  6. J

    Stihl 036 Pro limiter cap removal

    I would but they go through a plastic block and I don't think I can get the entire cap cut off.
  7. J

    Stihl 036 Pro limiter cap removal

    Saw was purchased in 2000, has what I gather to be the older style of plastic caps that have the wings on them. I clipped them off without removing them to allow turning the H and L screws. Problem is, they just rotate around but the actual screws do not move. How do I remove these so I can get...
  8. J

    Stihl 051 rpm at WOT?

    Thank you! I ran it yesterday and around 9400 rpm was all I could get. Looks like some carb adjustments are necessary if it is going to make 10,000.
  9. J

    Stihl 051 rpm at WOT?

    Just got a hand held tach and want to check max rpm on this old Stihl. Problem is I can't find any info on what that should be. Anyone here know?
  10. J

    Hand held tach

    Need to get one to help tuning my chainsaws. Which one do most folks prefer these days? Will use it on some older saws as well as new ones like Stihl 461.
  11. J

    Ethanol fuel additives?

    Local farm supply has the ethanol shield, I'll give it a try.
  12. J

    Ethanol fuel additives?

    I'm stuck with 10% ethanol fuels in my general area, hate to be using them in my saws, blower, etc but no other choices readily available. Is there any one particular fuel additive I could put in the fuel to help prevent the bad side effects of using this type of fuel?
  13. J

    Stihl 460 or 461?

    Who sells these already ported and ready to go? I know Wicked sells the Huskqvarna models with woods porting done, but I've not seen an ad for a Stihl like that.
  14. J

    Stihl 460 or 461?

    Thanks everyone for the info, guess a 461 will be what I end up with unless a really good deal turns up on a 460. It'll see use both felling and bucking, unless I just have to break out the 051 for the fun of it!
  15. J

    Stihl 460 or 461?

    Hi Folks, Been lurking here for a while, now need to make a post and get some info! I'm looking to buy either of these two and wondered if there is really much difference in them? Been a Stihl guy for 40yrs and need to upgrade a bit as my old 051 is getting too heavy! Will run a 25" bar on it...
  16. J

    Sold Masterminded MS660

    Hello, just registered on the forum and seen this thread. Is this saw still available?
Back
Top