Search results

Just curious @Eric howes . Maybe I missed it. But what model saw were you thinking of having ported? Steven

No Sir. I came down with the flu and haven't been able to do much of anything outside. I did find a plug with the correct threads for the oil cap and have a 16" bar mounted ready to go. So once I'm able to get outside I can run it a bit. Steven

Not a clue if you can order it separately, but I probably have a junk handle I can rob one from. Let me know if you need me to rummage for it. Steven

I think most people have learned that one the hard way. You can't run a outboard clutch like that without the cover in place if you had it apart for any reason. They don't get fully tight until they have been used to cut a good bit of wood. Steven

Couple more. Thought I had posted them here but must have only on o***p***e. That big load of rounds was a short haul about two miles. Didn't have time to make multiple trips that day. Had to go for broke. Not too worried about the trailer as it's a real odd duck. 7000gvw but homemade by a...

Runs pretty good. Doesn't pump oil (and cap is missing) The half wrap is smushed a little, the handguard has a small crack at the base. Otherwise doesn't look bad. $75 and actual shipping. The extra clutch cover goes with. Don't know why the pics loaded like that??????? Sorry guys...

Bump kinda forgot about this one. I used it yesterday. Good running little saw. Steven

Few hauls from this year. Steven

The 440, 4600 and 450's are sold pending payment. Edit: the 440, 4600 and 450's are paid and shipped. Steven

I know that feeling!!! And all to well! Steven

Echo cs-400 blown up bad. Echo $45 cs-370 has a broken ring and missing some parts. $45 Echo cs-4600 runs great, missing clutch cover, busted rear handle and clutch is kinda rusty. $45 Echo cs-440 complete but scored bad. $40 Husky 450 missing a bunch of stuff, fuel tank leaks, p&c look very...

If it was even remotely close to me. It would be sitting in my driveway right now. I'd sell the lift and add a dump scissors for what I would be using it for. A 5.7 vortec is not a expensive engine to swap out. Especially if you have a half dozen :innocent: Steven

You are in the right place for what you are looking for. @chipper1 always has some purdy and low hour stuff. Lots of big iron around right now. Steven

I'll stir this up for you. Echo 600/620p! I've had 562's and they seem to be the smoothest and most grunt stock. I've had 362 mtronics and they weren't bad pretty close to the husky, but a little harsh and not as much down low. But I like the inboard clutch for some reason. I've sold both...

One more bump. And I'll add that I would be interested in any g model huskies or Arctic stihl saws on trade. Running or not. Steven

If you are looking at the cross cylinder. Send them a message before you order it. They have a pop up piston available now. It will help with compression. Give you a little bump for your elevation. Steven

Rust oleum implement in jd or cub cadet yellow if they offer it. Steven

Thank you! Steven

Can anyone tell me the fitting size and length of the two hoses? I need to get a replacement set. I had measured them but have lost my notes. If anyone knows off hand it would be great. Otherwise I'll get them once I clear the snow drifts away from the building it's stuck in right now. Steven

Bump