Search results

Because the most of them dont even have the basics tools for autotune and MDG1 diagnostics tools dont even thing about are expensive one plier and one screwdriver is enough for do all the jobs but the stihl MASTER WRENCH SERVICE or the HUSQVARNA GOLDEN SERVICE is the first place in...

The most dealers are know and are educated from the stihl and husqvarna for the tools for the problems but theirs characters is like.................

The one problem is the depth , the other and bigest is to dont put the pump more left or right that the hole on the case is

Your problem maybe is a leak somewhere or a problem to the autotune for example the solenoids valves the better that you have do is to go the saw to a husqvarna service usually the saws can not iddling because of leaks , but here maybe the autotune make the problem

Also sometimes theese thing ( red line ) are more tight and metering level that keep the needle can't play free , check also for this

I have see this f..... ing problem in many saws , saws floods or boging just because the needle stucks , check again or try a new needle with metering level

Directly from the ms 441 service manual the two first reasons have to do with the needle Condition Cause Remedy Carburetor floods; engine stalls Inlet needle not sealing – Impurities in valve seat or cone Remove and clean inlet needle or clean carburetor Inlet control lever sticking on spindle...

No matter if the carb is clean and rebuilt , the carb needle stuck and the saw flood

you know better

so what is the problem ? you can't find from where the saw leaking or something ?

when it died imediately check if you have spark , i mean when the machine is hot , if not you go for coil , if yes check for other problems

Good that you find where is the problem for sure now you can repair it

Diferent methods for diferent situations all works good my friend

The carb needle valve stuck this is why the saw flooded

spark must tested inside the cylinder not outside

THANK YOU VERY MUCH

I need the latest edition of the stihl tools catalogue example edition 2015 if someone can help thank you

stihl ms 381 service manual please thanks in advance

Take off the muffler and see in what condition is the piston no need compression tester after you put fuel directly to the cylinder the saw run or run just for a little ? take a help from a friend tell him to put his finger to the carb and pull the starter rope and see if the saw start with...