Search results

Congrats on the MS211

I'll cast another vote for the 192T. You can make the saw a little lighter and cut a little stronger with the 12" Picco Micro .043" bar/chain setup. That's how I have mine set up now. I have not yet modded the muffler, but I move up to a MS211 when I need to cut bigger wood, then up to a...

MS192T with 12" .043" Picco Micro bar/chain Tune that baby right, and is does the job well up to around 6". Mod the muffler for faster/stronger cutting above 6". 8" and above requires patience or a stronger saw. However, for one handed pruning, the 192T with a 12" Picco Micro setup is about...

Indiana Jones and the Search for the Lost Noodles

Sawburger Hill A Saw Too Far

A candle that burns twice as bright, burns half as long? :)

It would be interesting if saws specs would list the HP/Torque curves. Perhaps it's not as easy to map a small engine specs with a dynamometer.

Keep using the 290/210 combo. Use them until their busted. Spend a little of the $$$ not spent on a new saw on extra loops and sharpening capability. There are more powerful saws in the same weight range as the 290, but they're really overkill for your needs. If you simply must have...

:agree2:

:clap: ONCE I GOT STARTED, I COULDN'T STOP. :)

heretic! We're all in search of Excalibur! :)

ms361 noodle fest

Because the rich/lean condition of the saw's tuning will drift as it breaks in, your observation is not out of the ordinary. Also, there can be a difference between hot/warm weather and cold weather. I know my 361 was difficult to start in colder weather until I made an L adjust to be just a...

Welcome to AS If you do a topic search for ms361, you will see this comparison discussed numerous times. I say this because, while you may get some responses, you will miss out on many responses that will not likely be repeated. The 361 is built to be run all day long and provide...

1st... Make sure H/L are set properly. 2nd... Leave DeComp alone 3rd... 3 pulls full choke, kick full choke off and pull 'till start. It's very easy to flood the 361 on full choke. You can listen for the gurgle of an almost start, but you can miss it. Only exception to rule 3...

Sorry to hear that. That explains why your discussion on the saw dropped off. :( Just wondering if it shared carb design with the older 200T, which also has it's moments.

Thanks Andy Have you had any issues with stuff getting inside the saw with your port?