Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. Paul Noon

    MS200T

    I was given this saw the other day, it's a non runner and in need of a strip and rebuild, can anyone help me out with a service manual? I would be extremely grateful for any help. Paul.
  2. Paul Noon

    Stihl MS181

    In need of a service manual for the Stihl MS181, can anyone help with a link or whatever, Thanks in anticipation, Paul.
  3. Paul Noon

    Stihl 041AV. Oil Pump.

    Thanks Hotshot, this seems to hit the nail on the head, I will give it a shot and let you know! Thanks for your input Paul.
  4. Paul Noon

    041AV Pump Drive Shaft Question...

    Hi all, I am in the process of reinstalling the pump on the above saw, has anyone any idea which way the bevel on the shaft should face when I push it back in. I am enclosing a picture of the drive shaft, I am saying that the pic is showing bevel up!
  5. Paul Noon

    Stihl 041av leaking oil

    Sounds like your 041 saw is leaking bar lube from the front of your saw (same problem I had) it is the rubber seal that is bad, next to the bumper spike there is a hole with a circlip, take off the circlip and put a screw into the threaded hole at the top the pump face and gently pull out the...
  6. Paul Noon

    Stihl 041AV. Oil Pump.

    I am in the process of rebuilding my Stihl041 AV, I have removed the oil pump and replaced the rubber boot and the Oring on the shaft, I have noticed that there is a bevel on the end of the drive shaft and I am not sure what position the bevel was in when I withdrew the pump, has anyone any...
  7. Paul Noon

    Hi.

    By All I mean All, i.e. Everyone. HTH...
  8. Paul Noon

    Hi.

    Thanks for the replies, I don't have facial hair but I do have snow on the roof LOL. I am in the process of rebuilding my Stihl 041AV, it was leaking bar lube from the pump access hole at the front, I have removed the pump and found that the seal needed replacing and also O ring on the pump...
  9. Paul Noon

    Stihl 041av

    I am in the process of rebuilding my 041AV chainsaw, I have removed the pump to check runbber seal and Oring and I notice that on the end of the pump piston shaft there is a bevel, can anyone advise which way this bevel faces when reinstalling it, I could also use a service manual .pdf for this...
  10. Paul Noon

    Hi.

    Just joined this fine forum and wish to say Hi to All.
Back
Top