Search results

I need the whole recoil or the rewind pulley. Also need the air deflector.

The rope has come out on the inside twice. First time, it took out the flywheel, debris cover and the coil. Second time just debris cover. Why would the rope unwind inside the cover?

Anyone know what this fits?

One side says Stihl 1128A, the other Gilardoni 327 A 2 D. Is that an 044 cylinder?

I'm looking for a good used jug & muffler for a 044

I need the small rubber, plug like, and vibes. Not the ones with springs, but all rubber. Also need a handle.

Bought a Makita case from RS Saws LLC, I think in Florida, bout 3 weeks ago. Never got it. Promised tracking number, never got it. Just a complete scam.

I can't get the one with the plastic bushing to stay together. Do I need to put a nut on the screw?

I possibly am going to need one. Let me know what you have.

I'm taking the coil & wires off. Does the spark plug boot cone off? Can't see any other way to get the coil & wires off.

How do you get them out? The screws are loose, the rest won't budge.

What size is the e clip on the clutch side shaft

Looking to replace the crank case on my 7900. Discovered a crack in the bar stud area. Ideally I would like to have complete, bare case with good crank. Let me know. Thanks.

Picked a very nice up this week. It seemed it the carb adjusted. Sounded too lean. Smash the throttle and it wots nicely for split second then screams. Sounds too high rpm to me. I adjusted high jet out to 2 turns,didn't change anything. What does everyone think the issue might be.

Seems I need a re-coil for my 10-10. Any out there?

Is it better to put a new gas tank gasket on or use RTV?

I need a dog for my 3400. Is there any out there?

I need to replace them. How do you back them out without harming the cover?

Guy gave me an 024 that didn't run. Cleaned p&c, pit new rings on. It fired right up but bogged and dies in the cut. New fuel line & filter and pulse line. Intake was fine. Put back together, same issue. Pulled and cleaned carb. Won't start at all now. Opinions on why...please. Thanks.

Will an Echo 24DOPS3881 bar fit on a Husqvarna 372XP?