IE: McCulloch Timber Bear, Backfiring and missing
Runs Great now
Wanted to make sure you guys saw this.
Thank You,I never thought that something that had spark and would (sort of run) Would be a bad ignition mod, But it was. I put the new one on Yesterday and choked it once it...
Runs Like New!!!
:rock:
River Rat and all Thank You,I never thought that something that had spark and would (sort of run) Would be a bad ignition mod, But it was. I put the new one on tonite and choked it once it fired and put the choke off and it runs like brand new!You Guys rock :rock...
Not flywheel key just checked everything looks good, By adjusting fuel screws it started to run almost good then started acting up again:deadhorse: :confused:
Ok, Ive got a McCulloch Timber bear Im working on, Long story short, Everything to do with fuel system is brand new. I finally got it to (run?)
Tonite but its shooting flame out the muffler And it backfires through the carb. Im still trying to fine adjust it but have the low screw in (or out)...
c-51 c-7
How many of them do you want? I`ve got 4 or 5 of them and only 1 needs a diaphram to run. The pull starters are about the same as mentioned here.
re
I`m also working on a saw doing the same thing, but when i hold the float needle down it will let gas in,otherwise It acts as if it were clogged. Do you have the type of carb that has the tube that pulses from the motor to the carb? and is it hooked up ?The carb I`m working with is a walbro...
re
Thanks Mark, I cant get this thing to run, Starts every time I yank on it, just wont rev up it just dies. Ive put in a new carb, fuel line . new fuel filter. I`m stumped here. I will set the high , low and see if it takes off,