I don't know if the timing was advanced. A saw builder on this forum sold me the saw and did the muffler model before it was shipped to me. It was brand new.
The service centre did say the written warranty is not very good. They gave my son and I a free rockstar and said they would look into it right away. The way this service center operated, I would purchase a Makita over a Stihl. Each Stihl store has to make profit and so this becomes difficult...
The saw was running great and all of the sudden it just shut off as if I turned it off. I wasn't under load when it happened, I was in between cuts. I wonder if the factory will set the timing advance correctly with the muffler mod.
The saw was running great and all of the sudden it just shut off as if I turned it off. I wasn't under load when it happened, I was in between cuts. I wonder if the factory will set the timing advance correctly with the muffler mod.
The saw was running great and all of the sudden it just shut off as if I turned it off. I wasn't under load when it happened, I was in between cuts. I wonder if the factory will set the timing advance correctly with the muffler mod.
Bought this saw 1.5 years ago with a modified exhaust. The pin on the flywheel sheared off which messed up the entire engine.
The Makita service center said that chainsaw warranties are terrible in general.
After 2 days they said that they will fix everything at no cost to me and I will have...
This article was written a week ago: https://www.forestry.com/editorial/equipments/review-test-new-ms-462-chainsaw/
I would love to find out how the C85 compares to Stihl RSLK Chisel. I do know you can't really use the 2 in 1 on the RSLK, but it might work on the C85. Any insight into this?
I...
I just purchased the 7910 with the HD filter installed. I also have the standard filter. My observation is that it is a nice setup. I don't really see how the air intake is more restrictive like someone mentioned. Outside of one comment, it appears most people who have the HD are happy with it.
I have read that you don't want to run a brand new saw wide open out of the wood, but at the same time you want to check the RPM's wide open with the Tach.
Do people tune these saws with the chain in the wood and under load, or do they open them up without a load on the chain and check the...
I am on the west coast, so Dolmar dealers are limited. I have a tachometer for monitoring this new saw I just received. Before I start using it I want to make sure this saw is tuned properly.
The H screw requires a special tool. Can anyone help me identify the tool I need to get for this saw...
I couldn't put this in the Tradin Post. I think you need special authorization. I want to net $7 a loop. I will use flat rate shipping through the post office so this will be an dditional cost for the buyer. I have more loops than 15. All the loops have not been touched with a file or grinder.