Search results

If purge bulbs were introduced on Pro saws before homeowner saws they would be all the rage!

A big 20 kv generator is going to use a lot of fuel and make noise at night. I use a 6 circuit transfer switch and a honda Eu 3000 for essential house circuits. It can run 24/7 and sip fuel. Can't even hear it run at night. I then have a 10k generac for the well and electric water heater. The...

these nozzles are are so hard to use that they INCREASE vapors because people take the cap off and use a funnel. Or just poor the gas directly out of the can spilling it all over.

Years ago when the 038 was the go to saw people would run 32's all the time. At least in West Coast soft wood. You could go 1 tooth down on the sprocket if possible. West Coast guys always exaggerate by about 4 inches! so a 28 inch should work fine.

pacific madrone, almost no bark, clean to split and stack. burns hot.

Had my 066 for about 13 years and usually run a 32" bar. At the time I ordered a 50" cannon bar for limited use (maybe once or twice a year). For this use it works ok and has the power to run it, but the bar is way too heavy for the body of the saw. Although powerful, the 066 is also...

On ebay right now they have a 024 p/c for $30.00 It is listed under STHIL not he correct spelling of stihl. There are always about 10 items listed from people who can't spell for people like me who also can't spell. Jim

trencher About 10 years ago, I saw one a little smaller that was a direct chain replacement and was hand held. Wanted to buy it, but it only worked with an inboard clutch and I had a husky at the time. have looked all over the net but have never seen one. it would be great for a small wire or...