Search results

runs regularly but irratic idle lately so took air filter off to check it out and saw the greyish **** in carb inlet. will try to do compression test tommorow. Might need to tear itdown and inspect also. today it stalled and wouldnt start like getting no fuel poured a little in carb and started...

I have 630 that has what i would to much cold start compression and i see a grey dust paste in the carb inlet neck so any input would be great. Wayne

Ok I think its a bad tabk vent because if I loosen the gas cap while its hunting the hunt goes away.

solo 637 hunts at idle but only after i refuel it after i run thru a tank of fuel . Runs fine on the tank of fuel it has until i refuel Any thought would be appreciated. Wayne

I will try to give it a little low speed fuel. i believe the low speed kick up is working it does run at a higher rpm when it starts. It just seems that it should start in 5-6 pulls with the choke on. But it seems that it will fire once with choke then i need to turn choke off but leave high...

I bought a nice used 2186 from my local dealer Curtis outdoor products real good dealer. Only problem is it seams to be hard starting when cold. But once started it runs great cuts great. I did not verify compression but i have a good standing with dealer and he said it was good so i trusted...

I have a CC string trimmer that im replacing the carb and its one of those epa carbs with 2 throttle air flow ports is there anything i should know special about adjusting the carb ?? wayne

impulse line was off thanks wayne

by fast i mean it wouldnt idle down and now it acts like its starving for fuel put in a new fuel filter and fuel line and its still acting like its starving for fuel it will stall as soon as i pull the throttle but if i slowly feather it up to full throttle it will come up to full speed. wayne

I have an ms 440 that seems to be starving for fuel. i was cutting a tree and got pinched and stuck pretty bad and after i got it out it was running real fast not and the chain wouldnt stop and not it went the opposite direction it is starving for fuel i changed the fuel line and filter with...

thanks will try that tommorow wayne

Im working on a 630 and im wondering what you guys would use as a base adjustment for this saw after i rebuild the carb later this week? thanks wayne

thanks i looked and looked and never saw that pop up list wayne

Is it really a big difference from 61.5 to 66.7 cc on chainsaw? I have a jonsered 630 and i found a 670 cylinder kit for it but other than having a fresh cylinder for it im not sure if its worth doing? also is there a way to get the writing on this page to be in english thanks wayne

well after alot of pain the saw runs it was the piston i bit the bullet and bought another piston and this one was just like the one i took out and the saw started right up piston on right is oem one on left is from baileys

I have a dealer trying to sell me a 51 cc for about 380 but not sure if i want it im really eyeing a dolmar 6400 wayne

so what would we say the consensous is on solos since this went on a rabbit trail? wayne

anyone know anything about solo chainsaws? wayne

it wont run but if i take the plug out and run the saw from the clutch nut with a drill it has great spark and a compresion test shows about 140 psi compression and yes to fuel plug is alway wet when i pull it out wayne

so no thoughts on if the 2 different pistons would make a difference? waynehttp://www.arboristsite.com/attachment.php?attachmentid=75102&d=1217200284