Search results

Finally had time to take some pictures. I'M missing a lot of parts. between the two i might be able to piece together a saw.

Sorry been busy. just cleaned out. ? As soon as i find my camera card i post some pictures. I bid on a HL supply rebuild kit. It has everything, im just wondering if its cheep junk? anyone use any of there parts? Id like to get these 2 saws build. Ill probably do a full restore powder...

I got two Ts400's. one is mostly complete. i am missing all the hardware but i am working on getting it. The other one is missing a fair amount of parts. but ill start with one, ill get pictures up here soon. Its going to take a while but i need a cutoff saw. there seems to be alot of parts...

Just use a sleeve or washers with the clutch spider to pull the crank to the clutch-side. then just evenly bolt the flywheel side on, you can also use the same washer method on this side. just got slow and keep everything even.

im still running it with the same tank/handle. My 066 rebuild on here came out alot better. but the saws still running strong.

this is not AS nomore

tried that but it was a no go. Ill figure something out id cut it off but i cant get any form dealer id have to buy 16ft of grip :dizzy:

I am pretty happy with it came out pretty dam good i must say ill run it tomorrow. Snows coming down guna be a long nite. I need big dogs, slide plate, grommet and possibly a carb housing if anyone has these leme know, theirs probably a few more things I'm forgetting. next saw ill clena up...

that's what i was thinking then just glue it back on

just about done needs grommet for carb and i need to blast and powder bar cover

used plastic weld to fix this, if i find a good one ill buy it? came out strong

debating painting handle probably will any ideas on getting grip off? if i can ill powder coat it if not ill rattle can it. muffler came out great

Got alot done on the saw today. cleaned up all the plastics except the tank handle. Sandblast first, then 320 wet sand, 5min in oven at 175, fisrt coat 5 min in oven, second coat 5 in oven, wetsand 600, 1 or 2 more coats final in oven for 10 min. Works great and looks good. If you don't 600...

If i only had that much free time, i would consider it for a fair price. Guna have to make a thread and post pictures

I owe Evan a huge thanks he did my muffler for me. did a great job to!! im guna give it a fresh coat of paint while im at it

Been a while, got a few small things done today. Got the chain break mec back together and clutch on. Also re-sanded the air filter cover and clear coated it. kept it in the oven at 170 came out fairly well probably work better if i wet sanded in between but it is a work saw and just wanted to...

MS660? should fit baileys has a list of models it will fit. The pin an clips were fine but if herd some of them have taper and could cause problems so i ordered stihl ones. Iv been so busy haven't touched the saw. I got the tank and handle on that's about it and the p&c is kinda on...

it don't make much difference, if I come by another one ill get it.

Got the crank seals in as well, rebuilt the carb and cleaned up the clutch and put new springs on. Flywheel on and coil, put all the av mmounts on and put the starter back together. What kind of paint could i use to paint the stihl name and line?

Finally got some more work done on the saw yesterday. Would have gotten more done but didn't have a piston bearing :bang: and started working on other things but i got a good amount done. Heated the cases to 300 for 20 min and put the bearings in. then pulled the crank to clutch side and...