Search results

under new ownership as far as hours it varies?? Scott

NY is a big state..... What part of NY I know a Dealer that is selling stock PS6400's with factory bar and chain for a lot less than that website you mentioned Scott

Oregon PRO91 Bar 160SPEA041 is a readily available PRO BAR Scott

Why are you using Bias Tires instead of Radials? Scott

Husky is finally starting to use Oregons LPX and LGX Cutter check to see if the part # is like H47X or H48X than Oregon Dealers have had a for some years now.. Scott

I have plenty that need runnin...... or plenty of NEW ones that need new homes as well lol Scott

Recheck the Part # I believe you looking at a HN 2450 PA, The HN = D196/D096 Homelite Mount, 2450 = 24".050" Gauge and PA = 3/8" Sprocket tip its not the proper mount but should work with little modifications. The bar your looking for would start with HV or HVT Scott

I have a new 90cm Oregon Harvester 16H series bar part #903HSFL205 that is .404".063" also have a 30" GB Harvester .404".063" Scott

Wow, OK TAPER LOCK BUSHINGS.... On this set up The 3 open holes draw the hub into the pulley to tighten. THE 3 TAPPED Holes in the Bushing are to Remove the Pulley from the Bushing. Remove the bolts that hold the pulley to the bushing and install them into the tapped holes lube the hub with...

here is a search of local airstrips and airports depending on weather you flying a private or commercial flight http://www.allplaces.us/afz.cgi?s=12834&rad=30 Scott

their probably is a missing decimal point between the 3rd and 4th digit on the hour read.... The Splitter loosk clean from the 1 pic in the ad $7500 seems fair they are $9300.00 + new Scott

What is a Jonny Red???????? only a name they do not manufacture saws anymore? to my knowledge they come from Poulan Factory, Red Max Factory or Husky Factory dont they? To My Knowledge all The above mentioned plants send saws under 62cc with ANSI Compliant chains and bars? Maybe Im wrong cause...

Not a dolmar thing?????? ITS A FEDERAL THING!!! Called ANSI Standard! Any ChainSaw under 62CC Has to have Green/Blue Label Safety Chain from Factory at point of sale. So Saws that fall in that class are supposed to have ANSI Bar and Chain Approved Combo's THis has been going on for years now...

Strato or non Strato the EPA Tag is their rating of how long they want the engine to Run Clean to EPA Standards some engines have 75 some 125 some 200 some 300 etc. Scott

Nothing to due with engine life... It is the rating the EPA wants the saw to RUN CLEAN at Scott

Ths PS6400C with a CAT is the closest model to the New PS6100SAS With No Cat Does have a 300 hour EPA rating if that Number is that important to you.. Scott

Redmax did Develop "Strato Charging" BUT they DID NOT Develop the GZ7000/Husky 570 That one was Husky's fault!! Scott

puller # 957434000

I dont understand Your Issue....... Yes there is A SPECIAL TOOL that a Dolmar Dealer Should have in his took set that removes the gear from the crankshaft. But then again You bought it with a SOLO Version and I dont know what tools they have available to Their Dealers. But Dolmar had 2 versions...

After testing and running this new PS-6100 it is going to be a great runner It is FASTER than the PS-6400 also Lighter it holds a huge amount of fuel so that is great as well. Yes this is a New Platform and design they have been working on it for a while now and its time for Dolmar to release...