Search results

Looking for 1 bar stud for a gear drive. Looks like any of the large frame gear drives can supply that piece. 55 on up to the 895, any 1-6x series, and a 640. Part# 51631A PM with what you have. Thanks, Chris B.

After working on my 890 and 795 recently, getting a hankering for an 895. Anybody got a complete one for sale. The more complete and good condition, the better. Thanks.

I am putting together a 125 and am looking for a couple pieces. A good clutch cover and a good tank that isn't corroded inside. There may be other missing parts but these 2 stand out as the most important ones needed. Let me know what you have. Thanks.

Long shot, I know, but looking for a bar/sprocket cover for my Super Twin. Got 2 saws and 1 cover between them. Let me know if you have one or know of one available. Thanks, Chris B.

Specifically looking for rivets and/or preset tie straps for the big Disston chain. The plain rivet measures .281" dia at the center, .190 dia at each end and around. 295 OAL. See picture. I suspect old Oregon 3/4 chain uses a similar rivet with a larger diameter. That would work. I have no...

Looking for the flywheel side case half for an RA in good condition. Mine is cracked, would like to replace it. PM with what you have. Thank you, Chris B.

Looking for a Poulan air filter to fit the above models. Fits other Poulans and and as far as I know they are all the same. Thanks.

Back to needing a good piston for another 211 project, my KA-211. Seems the front cylinders don't hold up very well on these saws. Anyway, I could use a good piston to replace my scored up one. Prefer with the rod attached so I don't have to mess with the wrist pin but I'll take what I can...

Wanted to throw this out there. Looking for a complete model AB. PM with information.

Looking for 50 drive links of 9/16" .063 gauge chain. Doesn't have to be new, but don't want chain that is shot. Prefer Oregon #4. PM with what you have. Thanks, Chris B.

Looking a Tillotson float carb for this saw, ME-5B or ME-5A. Let me know what you have. Thanks.

Looking for an early 245A cylinder, no decomp in good condition. PM with info. Parts saws are OK as well, as long as the cylinder is good. Thank you, Chris B.

Anybody here have a 3/4" pitch sprocket for C type chain to fit a 211? PM with what you have. Thank you, Chris B.

Anybody here have a 3/4" pitch sprocket for C type chain to fit a 211? PM with what you have. Thank you, Chris B.

Looking for a small pile of bar bose rivets for the Oregon old style 3 rivet tip. I measured the OD at around .184. PM if you have some. Thanks.

Looking for a good piston/cylinder for a DA-211. I think a piston alone would be fine but a good set would be better. PM with what you have. Thank you, Chris B.

Looking for a 3270 Auto to complete my set of 77cc saws. I already have a Super 3270 and a 3270SC but not the plain 3270 Auto. Anybody with one up for grabs or has a line on one, PM me. Thanks, Chris B.

While I am needing parts, I also need the following: a complete exhaust, the chrome, two-outlet, side exhaust style. Would have been found originally on the 14-20, 14-50, 15-20, 15-60, 2400, 2460, 3200. Chris B.

What do you guys think killed this top end? Piston doesn't have many hours on it near as I can. Chris B.

Anybody have a good oil cap for the 211? Mine is busted up, missing the vent screw. PM with what you have. Thanks, Chris B.