Search results

Well I no longer need a seal right now I ended up getting a complete cylinder and crankcase on ebay and it holds pressure so back in business.

I was slow cooking.

.625 shaft 1.14 bore .185 width

Well I have finally got done grilling and back to the 550, I have pressured up the case and found the clutch side seal leaking. Does anyone have a lead on one of these? I can't find one anywhere even on the SKF seal site I can't find a seal that matches these dimensions, help would be appreciated.

From what I read they are mostly from the Mississippi east but there are quite a few around here, this is my second haul this year of red oak.

I got it all split today got two rows 20ft long and 5ft high.

Well thanks for the advice, I was thinking of renting one just to see if I would like it.

Well this is my second haul of red oak, I got two trailer loads about two weeks ago from another guy I know.

You were right.

Thanks I think if a traveling salesman came by with a vertical splitter I would have bought it, this stuff had alot of knots in it.

If I keep getting this big stuff I am going to give in and buy a vertical splitter.

No shindaiwas today just stihls I had to use my 660 because of how big it was and my 440. All the limbs had already fallen off since it has been dead for a year so there wasn't any small stuff to cut, i brought my 488 just in case though.

It works good for me but I have not tried any other splitting wedge, but I have also had it for 5 or 6 years and use it often in big stuff.

Fiskars super splitter and some of it with my estwing 5lbs splitting wedge.

Got some wood today loaded my 18Ft trailer with 30" sides and the bed of both my pickups with red oak, it was a standing tree that died last year. I would say it was 36" at the base and probably 60-65 Foot tall, I cut it with my ms660 with a 36" bar it pulled it great, and split it into small...

I am just about done burning some from 3yrs ago.

A 757 would be a good saw and you can still get parts for it and you can still find them around more readily.

It can't be to big then.

Was this made to replace the 488? My local dealer never had one.

I have one but I don't remember where I got it but I have been waiting for some parts for it. When I got it the piston was burned up but the cylinder was good so after it set for a year and I couldn't get a piston I took the old piston and sanded it down and cleaned it up and put some good 695...