Search results

Looking for a muffler cover, air filter and air filter cover for a John Deere 70V. If anyone can help out please pm with what you want including shipping to zip 18974. Thanks

I love these saws! I started off with 1 XL2 like in the pic above. Rebuilt the carb with new lines and duck bill valves. Put a new 14" bar and Stihl 3/8 Pico chisel and it really runs well. The XL2 is nice since it has the 2 triggers. The front one allows it to be run like a top handle and the...

Looking for a coil for an Efco 940 / John Deere CS-40. If anyone can help out please message me. Thanks, Dave

Bump

Looking for an old style (small) air filter for a Stihl 024 / 026. PM me if you can help out. Thanks, Dave

Please message me with what you have and what you want for it. Thanks, Dave

Looking for an IPL and service manual for a Stihl TS350. Thanks in advance, MP5N

Looking for an IPL for a Homelite 2000. If anyone can help out I'd appreciate it. Thanks in advance, MP5N

Just wondering if a MS192T coil is limited? Thanks, MP5N

Looking for an IPL for a Stihl MS362 CM. This is the one with the M Tronic. If anyone can help out I'd really appreciate it. Thanks, MP5N

I did a little digging and found the 440 and 460 have the same stroke, 36mm. So what's the benefit of swapping a 460 top end onto the 440? On the surface you'll end up with the same displacement as a stock 460. Does the 440 have a different length rod or is it a lighter chassis?

Brad, I'm assuming you can do the same with an 044 / 460, correct? Thanks

The Stihl boots are expensive, but the only option as far as I'm concerned. I bought a few of the aftermarket ones to evaluate recently and don't like them at all. The accordion section is solid which won't allow for any movement with the top handle. With the cold weather they get hard as a rock...

If it seals for you this way then you're fine to check the engine assembly.

No real reason. Either is fine.

From the picture your 2 AV mounts look OK. Check the 3rd ( the one mounted to the tank) and give them a tug to make sure they aren't torn. Check to make sure the 4 screws holding the muffler together are tight. They have a way of loosening over time.

I do over 30 200Ts a year and this is one of the most common areas for an air leak. Don't use sealant, teflon tape or anything along those lines. Get yourself a NEW Stihl intake boot P/N 1129 141 2200. The old ones degrade over time do to heat, vibration and contact with fuel. Just remember to...

I tried a few of the Chinese carbs on a strong running 200T and it didn't run well. Put the Zama back on and it ran great. They run like they have an air leak. I'm going to bush the throttle shaft and see what the results are. It's a PIA to have to go through this, but I'm curious to know what...

Just by comparing the photos everyone selling these has they certainly look similar.

I bought 6 of these and tried 2 so far and they run very poorly. Like I said I swap out a new Zama and the saw runs perfect. I've been running the Zamas and Walbros for years. I've had good success with rebuilding or deleting the accelerator pumps, but if I can find a aftermarket that works I'd...