Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. B

    stihl 026 chain lub clogged

    What's the best cure to get my chain and bar lubrication system to start working again. When it was new it always continued to slowly leak down on the chain and into the bottom of the orange plactic case the saw came in. Now after 18 years it seemed clogged. No lube at all dripping down...
  2. B

    Stihl 026 Carb Removal

    Stihl 026 Carb Replacement. Time for a new Carb. I'm not wild about the dealers new EPA mandated carb with no high end adjustment and prefer finding a Carb with both an High and Low carb adjustment and the 3rd screw for ' idle' adjustment. The Walbro WT-194-1 is a pre EPA mandated Carb...
  3. B

    Strange Sthil intake manifold gasket

    thanks for saving me again, PioneerGuy. My old carb of 21 years died from ethanol in the gas and for some dumb reason, I put the saw away - didn't drain it- didn't fog the carb -just forgot and now I'm paying. My Carb is deader than dead. Gaskets as stiff as carboard which killed the...
  4. B

    Strange Sthil intake manifold gasket

    My new Carb is coming in the mail. I don't see a traditional gasket to join the face of the carb to the inlet manifold on this Sthil 026 or should I say, what I call a gasket that I would cut out from a sheet from NAPA appears to be a much large black rubber sort of gasket at the point where...
  5. B

    best Sthil repair parts center

    Mounting the Carb The other issue. My new Carb is coming in the mail. I don't see a traditional gasket to join the face of the carb to the inlet manifold on this Sthil 026 or should I say, what I call a gasket that I would cut out from a sheet from NAPA appears to be a much large black...
  6. B

    best Sthil repair parts center

    Well, too many of these on line parts places for Sthil seem scattered and far from offering a full line on their parts offering. In my case I have an 026. If I want common parts like a carb, chain or bar it's easy to find. If I want to find a seach engine that will list ' all' the parts that...
  7. B

    Stihl 026 Carb Removal

    Brages, Thanks for the come back and photo. I'll give that brass screw another shot of penetrating oil and hope it comes off tomorrow. At least I know it's the right one now.. Thanks Blair
  8. B

    Stihl 026 Carb Removal

    PioneerGuy600 Thanks on the pulse and the location of the screw on the handle. One last issue. There are only two orange plastic covers on this saw. One slide off cover for the air cleaner , that is not the one I am questioning. The much larger orange plastic shroud that goes all...
  9. B

    Stihl 026 Carb Removal

    Oscar, Thanks - I found the 1 screw , at the bottom, which I did not see initially. You gave me the clue and saved me from cracking the black plastic top- thanks. While I'm here I see the impusle tube. For a test without a gage I'm thinking a drop of oil at the end of it - pull the...
  10. B

    Stihl 026 Carb Removal

    Well, the manual is close to useless in this one aspect of removing the Carb from a Sthil 026. The throttle that is really a linkage of a bent wire going from the index finger trigger on the handle and then this bent wire twists its way over to the linkage on the carb itself so you can go from...
Back
Top