Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. PhilB

    Want to buy "Chainsaw Lumbermaking" by Will Malloff

    Amazon has it. https://www.amazon.com/Chainsaw-Lumbermaking-Will-Malloff/dp/1626548447/ref=sr_1_1?ie=UTF8&qid=1486748950&sr=8-1&keywords=Chainsaw+Lumbermaking Phil
  2. PhilB

    My oiler

    Flow to head isn't a linear function but flow increases as the square root of the head. i.e, the flow would double if the head was increased four times. Using Bob's experiment: as the head is halved from 30 to 15 cm head, one / the square root of two (0.707) times 6.8 gpm equals 4.8 gpm. Close...
  3. PhilB

    Cannon or Granberg?

    One operator/two power units can be done but it requires quite a bit of fabrication. Phil
  4. PhilB

    Sealing endgrain

    I wouldn't use car wax as I think it has silicon in it which would give you problems with finishes.
  5. PhilB

    new project: milling BIG beech/mill build.

    Nice Mill and well done video.
  6. PhilB

    I need a bigger mill

    Here's a link to rails : http://granberg.com/product/mkiii-chain-saw-mill-handle-and-rail-set-56 They have other lengths too. Phil
  7. PhilB

    Wheels/casters

    Here's some other choice's: These are less expensive. You would just use the wheel. The axel bolts are probably metric, so you may have to re-drill the holes. They are available at grizzly.com.
  8. PhilB

    Wheels/casters

    Here are two possibilities: Phil
  9. PhilB

    Wheels/casters

    Check Grizzly.com or mcmaster.com
  10. PhilB

    Twin powerheads double ended bars

    Another alternative is Plasti Dip.
  11. PhilB

    Twin powerheads double ended bars

    Liquid tape spread on the metal part will help cushon the throttle to prevent wear. Build up several layers until you get the thickness you want.
  12. PhilB

    Twin powerheads double ended bars

    I use it just for milling. Phil
  13. PhilB

    Twin powerheads double ended bars

    I've just have the two power head mill. I milled a 32" width (average) by 10' long red oak in slightly over 4 minutes. I have planed to make a one power head mill but other projects and obligations keep getting in the way. Phil
  14. PhilB

    Twin powerheads double ended bars

    No. Phil
  15. PhilB

    Help id'ing this mill

    David, It appears to be a Logosol M5. It's part of a complete system. Phil
  16. PhilB

    Where (else) to get square tube for granberg rails?

    I use square nuts with a chamfer ground on two sides so 5/16 inch bolts can mount accessories on 80/20 series 15 rails. These nuts give a good purchase on the rails.
  17. PhilB

    want to build a logosol anyone do this with pics ideas

    scor440, I always like this youtube but I forgot the link. Thanks Phil
  18. PhilB

    remote operated trigger/throttle

    Pond Hopper, I drilled through the handle between the ribs, but a clamp on remote throttle would work as well. Phil
  19. PhilB

    66" bar + MS880 = Saw Dust and Slow Cutting. What's wrong?

    Zach, Thanks for the link. Phil
  20. PhilB

    remote operated trigger/throttle

    Here's what I did for my mill
Back
Top