Search results

It definetely varies from region to region.......even over here on the west coast we could d#%@ near get away with a 20" bar now....they wont let you cut anything makes you smile when it hits the ground anymore. :chainsaw:

yeah I agree looks like an Oregon anti kickback chain...I'm not a fan of these at all.

Just wanted to know what everyones favorite landing saw is?? I usually use a 440 mag with a 30 in" bar, and a 56 on hand for backup. Whats your combos?

All of the saws that you buy have a recomemded bar length that the manufacturer believes would be best.......depending on their size they always recomend the smallest bar, but they usually run a size or to bigger than the smallest recomended just fine ;) Id say put the biggest bar on the...

I agree, even if you are able to look and run a saw before you buy it there is always that chance that it might not run tomorrow......I know a guy that wont even sell his old saws it could be just 4 or 5 years old just because of that reason.....personally I wouldnt buy a saw on ebay. But you...

Thats about the size of a paulon "wild thing" I believe

The most common problem is that the chain isnt sharpened the same on each side......bending a 32 inch bar is pretty hard to do....and you would definetely hear the difference, let alone see it.

Would that work with this kind of a setup??? Im just thinking that if you hooked them up in a series you may have to be pressing both levers to get the oil to flow through???

I would just tee them....saves money and a small amount of time. As long as you know your pump is big enough to supply both feeds with pressure.

You are by no means a snob......damn near everyone at some point in their life calls it something other than it is....I have even heard "that thing!"" haha all in all bar pleases me the most

All of this new biodegradable safe for the ozone is a bunch of bs....same goes for the ethonal crap....It P$%@!#s me OFF!

I guess that answers my question..... :)

Really???? Dont get me wrong or anything but, are you worried about pulling wood persay and not being able to please your costomer if you use a chainsaw???

I agree with 056 I agree with 056........A skip chain will cut just fine if it is sharp. Also just as 056 said, a little trick is to file your rakers, which makes any chain cut better. The more you sharpen your chain the smaller they get, therefore you file your rakers down every other or...

hey any of you guys own a two man saw. that is like hanging on to a fourwheeler. i own an old two man Mall. it screams. especially with the mufflers cut off. yes i said muff ff lll errrrs.:clap:

sorry to break it to ya but thats probably why they sold it. (because it was hard to start) they may have wanted to try and make a somewhat souped up saw but just couldnt get it done. your best bet is to rebuild the carb in my opinion. but you can make a homemade choke if your more into...

sorry to break you heart jason but ive seen him do it.

over here in eastern oregon, around unity to be exact. id say its about 80% sthils 20% huskys, they use 046s on most of the landings and 066s out on the mountainsides fallin trees. personally i like the 046s though not too big you can pack em around but big enough you can do just about...

hey ted its me landon. and i have no clue. get back ta me.:cheers:

I'm sorry to say this but, you should stick to your word, that's the way life is.:bang: