Search results

460 same weight as 455 more hp. Shep

Goes under carb. Most are rotten and gone. Resident 44 lover. Shep

No gasket on intake. Fought one myself wound up bad coil. Coil would show cranking spark. When coil advanced it would die. Shep

Good deal!!!!!!! Shep

I have a 665 converted to 681 it's an ANIMAL!!!!!!!! Shep

@fordf150 has stihl to Dolmar adapters, among others. Shep

Same as Dolmar 7900 just renamed Makita. Outstanding saw he will love it. Shep

2100 is the only saw I know of rated by factory for 48" bar. If IIRC. Shep

IIRC Brad used it or something similar. Shep

Same here. Pull them with a sheetrock screw. Shep

Wise move IMO. Bought nice, running 359's on EBAY $225 and less. Shep

Beautful! Been looking for one as I have a NOS PC. No saw funds. Shep

Yes it's OK to switch. As said need to tune for mix you are using. Low is screwdriver, High is DD specialty tool. Can get them on Ebay and Amazon. Shep

32:1 is for the bearings. Just tune for mix you are using. Shep

You will Love It! I have 4, 1-ported, 3-stock. I HIGHLY recommend 32:1 for mix ratio w/synthetic oil NON-E gas. Shep

Didn't know that. Thanks. Shep

028 Super is 46mm. 028 is 44mm IIRC. 024 is 42mm, 026 is 44mm. Shep

Maybe this will help. Been years since I worked on mine. Shep

Can't go wrong with the Makita 4300. Easy start lots of power. Dang near bulletproof. MM is easiest I have ever done. Shep

Old 61 Rancher and 266's. 2 part ignitions. Shep