Search results

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
  1. R

    Shindawa 580

    So I realize this is an old thread but can anybody tell where to find an intake manifold for a Shindaiwa 580 I just picked up?
  2. R

    Husqvarna 455 Rancher idle problem

    Well I tried the adjusting the low speed jet and nothing. Still the same problem. So I tried blowing through the fuel tank vent but couldn't, isn't air supposed to beable to go from the outside in? Now I'm curious to if this is part or all of the problem.
  3. R

    Husqvarna 455 Rancher idle problem

    When I lean it out it acts as it should, higher rpm's but it does eventually die. I'm not sure if this is from being to lean or the problem I'm trying to diagnose. Whatever the problem it's only at an idle or at least that what it seems like cause I can run half-full throttle all day long with...
  4. R

    Husqvarna 455 Rancher idle problem

    Ask and you shall receive :)
  5. R

    Husqvarna 455 Rancher idle problem

    Throttle response is good but when the engine warms up you have to pump the throttle to get it to rev up, if that makes any sense. The fuel filter is new, as I installed it thinking this might be part of the problem. The tank is not getting pressurized that i can tell.
  6. R

    Husqvarna 455 Rancher idle problem

    Hey everybody, I've got a 455 rancher that runs and cuts fine but when it's warmed up it will idle for 10 secs or so then rpm's start climbing (like it's running out of fuel) then it dies. I put a new carb kit in it since the diaphragm was a little stiff but not to terribly bad, but still same...
  7. R

    Husqvarna 395 any good?

    I just bought a 395 from a guy who needed the cash and am curious if these saws have any problems or common malfunctions I should know about? I've never been around one of these monsters but I do have a 372xp which I love. I'm hoping this 395 will be just as good of a saw. Any help would be much...
  8. R

    372xp

    I'm new to engine building so I'm curious what are you guys talking about with pop-up?. Also what's the benefit of putting windows in the piston?.
Back
Top