Search results

add WVO & burn it? or in paper bag

Indeck Energy: Ash Content Related to Wood Pellet Stove Configuration - MarketWatch

Soak it in some kinda oil?

Move the wood from center/bottom so to ,ideally, create a wind tunnel under the center of the pile, its the thought that counts

Tree stump of proper length & slightly smaller than the diameter of the fluepipe allows for copper tubing to be wrapped around the stump to make a coil which fits snugly on the outside of the fluepipe. Barometric damper above the coil may help. Call local University for heat transfer mechanical...

+ Residual steel fragments from the brush decay the SS lining.

Coals, like coal, produce useable heat from a grate & air through the grate & coals/coal.

Heat dump would be a fusible link that melted when the temp got too high & possibly overheat/warp the furnace. Foremost, I think you'll have to replace the elbow with a tee & figure out how to get the top of the tee to open when furnace overheats.

I think its better to adjust the size of the firebox by adding firebricks than it is to minimize the load.

You need a "heat dump" from the upper duct in case the power goes out? So the furnace doesn't overheat.

Bathtub is made of cast iron, dump has great deal.

Water boils @212*f, some air circulation would remove the moisture better I think?

Worst case scenario is, place the wood on anything & the cover with a tarp to ground level. Then, the warmer ground can migrate humidity through the pile to the cold top of the tarp.

Check the top tile for cracks. If not cracked, chimney may be ok. If hesitant, hire a pro to drop a camera & inspect the whole chimney.

The stove & chimney are full of uncombusted gas & when it combusts it explodes. Simple fix may be to open the stove door & let the gas evacuate before reigniting?

Ventless LP heater ideally located on N side of drafty house or wherever the winter prevailing wind comes from.

How dry & what size is the wood?

Considered downsizing the firebox by adding firebricks?

Yes & I wonder if the creosote at the top doesnt act as an insulator?

I remember a post where Kuuma offered Yukon {CrappieK] to pay for Intertek testing. What happened?