Search results

2019 Good condition except for the ding in the front. Does not affect the oil tank.

Very good condition. pho. $1400 US

Affordable but poor design. The winch is underpowered, the incoming chute and splitter are not on the same angle so after cutting a round it doesn’t fall down into the splitting area very well and gets hung up on the splitting ram. The wedge is vertical with this wing on the top that gets jammed...

Once I make a cut it can take 45 sec. To 1.5 mins between cuts. sometimes I shut the saws off other times let them idle. when I have to grab another log I shut the saw off. Which saw would be better for this process, the fuelie or mtronic? **** them down or let them idle?

Good condition PHO. Plus shipping. PayPal. Thanks

Good condition. pho. Front top screw broken off and back screw hole could use a helicoil. Both on pull cord side. $550 plus shipping.

I cut hardwood, maple and ash. So I use a standard notch cut, but my sawyer says I should use a humboldt. He thinks that it costs more time to cut off the flare on a sawlog vs me not wanting to leave 12” of board feet on the stump. Which way to go?

What is happening to my Maple trees?

Good condition, not an R saw. 2011. $450 plus shipping.

Does anyone make a light small mount bar in .058 24”?

Excellent condition, west coast. Not a heated handle saw, just the cover. PHO. 51.4 cylinder with wiseco piston. $900 plus shipping PayPal F&F or add 3%.

I don’t need the p&c or carb.

Decent condition, hole in tank repaired with epoxy, seeps a little. Crack in top cover covered with electrical tape. $350 shipped PHO

Good condition 2012 build $650 shipped. The only issue is one of the top cover clips pops off and the wire to the heat switch broke.

Looking for one in good condition

What is a fair price for a good used 461 Arctic?

As new 565, only has 4-5 hours, in excellent condition. PHO $800 plus shipping Paypall F&F

So if I was ever searching for a new brand, it’s a tough decision. There are no husky dealers around me for miles. The one I spoke to is now selling Echo because he can’t deal with husky anymore. The computer cost him $1500 and customers don’t like paying $50 just to hook the saw up. Echo 8000...

So if I was ever searching for a new brand, it’s a tough decision. There are no husky dealers around me for miles. The one I spoke to is now selling Echo because he can’t deal with husky anymore. The computer cost him $1500 and customers don’t like paying $50 just to hook the saw up. Echo 8000...

So this thing was leaning 3 different directions, first stem wasn't bad just had to tickle it a bit. The second one however I was trying to swing it, no go. So eventually cut the bottom of the stump to drop it. There might have been a little pucker factor involved. It split down the middle was...