Search results

Maxima Quick 2 Mix mixing cup is all that I used in the last 10 years. It takes the thinking out of mixing any ratio. Here is a link with the best pictures I could find of the cup. The lower right picture shows the mixing chart. http://www.abcbike.co.kr/shop/goods/goods_view.php?&goodsno=2629...

More like back from the dead. LOL Later Dan

Its hard to run a stock 346 after you get to use a good ported one, isn't it? How did the yellow and black saw get in the pile? Later Dan

Thanks. Its good to be back. I am not feeling 100% yet but I am up and around and alive. It looks like you have a good inventory of 346's. Later Dan

Less then 1/2 of the cost of a new saw in any country is a good price for one in that condition. Later Dan

I will do it. Any of the site sponsors on here can do a good job on a 372. Later Dan

I wonder how many years it will take him to update his site? The 346 he has listed is the old edition and his ad states 2.7 ci -45 cc. Later Dan

All of the new 346's I picked up came in a box with power head only. I have never seen a 346 shipped with the b/c in the same box from Husky. Later Dan

Can you post a picture of those partially clogged jets for us? Later Dan

You would think that with the shorter stroke it would turn at a higher rpm but that didn't happen. I had the same thing happen with my 346 that I grafted a 357 cylinder on. I liked that saw but unfortunately is was stolen a few years ago.

I used the 044 carb. I dont remember what muffler I used but I can remember I had to cut the muffler inlet and weld it back in. The angle was way off. I am getting old and I did that over 12 years ago. If your oil hole in your case is not blocked, try another pump. Later Dan

I used the 038 super with the 50mm bore. You will need a piston with a pin size of the 028 rod. I used an 044 piston with the 10mm pin. It made a lot of torque, not many rpm's. Later Dan

You posted a few pictures while I was typing. jughead500 is correct. Measure your bore again. Later Dan

The 028 and 038 cylinder will have a screw hole in the clutch side for the cylinder top cover. The 036 cylinder will not have that hole. The 028 originally came in three bore sizes 42,44 and 46mm. Check your measurements on the bore again and make sure your at 48mm. It is possible to install an...

Remove the strato, grind and cut. LOL Later Dan

John I don't have any sound on your video. I have seen a lot of crank side bearing failure on the 365 and the 372xt. I have heard the cause to be various from faults. I think that it is a Husky design error. The 365 or 372 case is a proven design and it worked for years until they added the...

I ported my Stihl FS 85 trimmer years ago. Its running a carb off of a Stihl 026. Later Dan

Find a new dealer. Later Dan

Thanks Troll