Search results

Looking for some mcculloch 1-40 parts. Need a front handle, and a starter cup and a clutch cover with spike. Thanks

I believe a 621 ignition will work if you don't find one.

Do you have a extra bucking spike lying around anywhere?

Hi I'm looking for a stihl ms200t service and IPL manual Thanks for help

Is that carb a hda 120? The metering lever should be level with the cover base. If it's dumping raw fuel in the muffler that's your problem. Easy way to tell if you have no tank vent is to pull a vacuum on the fuel line from the tank with the fuel cap on. If it leaks down you have a vent.

Finishing up on Daves custom s10 then diving into a full resto on my mall 7 g

Any word or interest in staples gtg this year

-29 here dryer vent froze up might go spearing today

I'd say the motor is going to melt down. 120 volts x 15 amps = 1800 watts divided by 746 = 2.4 hp. Give it a try and see. Good Luck

That will be a workout for a electric saw. What size are you milling and the species. Milling is the hardest a saw will work and will give a death sentence to even the best of saws

I live in Cohasset 80 miles NW of Duluth off hwy 2

I have the same saw here but mine is the auto tune it needs bearings and seals

did you do the porting? dang that hurts

People here are.starting to ice fishing and spearing

-11 here brrrrrrr:cold:

I need a decent top cover without the compression relief hole and a complete filter and cover

64mm the parts have been blasted except the one head with the CR and the piston and rod, bores are in great shape. PM offers I'd like to sell as a lot but if more than one has interest I will split up.

I'm looking for a decent 4" 3 jaw chuck with key. The treads are 1" x 10 TPI Thanks

Thanks. I have one set left.

Hi I'm looking for a Husqvarna 257 shop manual. Thanks