Search results

First step before dealer is to find someone parting out.

Ok, buddy smashed his saw up good today, needs some parts. To start with he needs the following: 1 1128 350 0832 1 Tank housing Bent the wrap handle good and busted the plastic up where it bolts to the underside of saw. Looks like he will have to replace with the above PN. Anyone can help...

will this tool index half skip?

Thanks guys for the replies, A1LM looks to be full chisel round, I'm looking for square.

Can't seem to find it or maybe overlooking it, Does carlton make 3/8 chisel bit?

I agree with Erick, I only fill my oil 1/2 full adjuster set at mid point and I have never seen a burnt bar on my 440/25" and the chain is lubed nicely, my buds have 460's/25" with no issues. Actually if i run my adj'er full open it gets tooooo much oil in and around my drum and clutch. If...

Good Deal, thanks Lakeside.

I failed to mention in my post that when I said stop the chain I meant you can actually bog the saw down and that is with minimal pressure, it just ran out of grunt. If there were clutch issues the motor would still rev? I ask because he did install a used clutch from fleabay, the drum looks...

Schrader valve is located on the guage block I will check with him on gasket tomorrow Very good info, thank you Sounds like first thing to do is locate another tester and start again. Thanks fellas, I will keep updating our progress.

looking for compression #'s on the 084AV, buds having trouble with his, idles and accelerates fine but when you lean on it in the cut you can stop the chain. Neither of us are mechanics (shade tree yes) so we started with compression and 130 is all we could get. He did have the jug off and said...

one can do the same with copper fittings from the box stores:) Although it wont give any insight on what is being put together in Virginia.

My dealer sells and services both, I liked both brands, each had there pros/cons but when I asked the question I got the answer Just as Freakingstang put it.

For me full skip has proven to be the better choice, I pay $15.90 for 33RSF72 vs $20.90 for 33RSC72, chain maint turn around is quicker and I would need more daylight to cut before speed even factored in. It is rougher / kickback to bore cut with but that was just a short learning curve, In...

Looking at stihl's promark saw boots, anyone have any comments on these boots? i.e wearability, durability.

Need to replace my boots, looking for the viking leather upper tusks (VW78) I believe they are discontinued, maybe someone has a pair collecting dust. Shoot me a PM, Thanks Tom

I would think the 441 is too new of a saw to really satisfy your most importants, and that is most important:cheers:

Street clothes+PPE, 20F you dont need insulation for cutting firewood. Carhart pants, tshirt, pullover windbreaker, really you have alot to do so dont be standing around getting cold. :givebeer:

5Shot, thank you for the offer, very kind of you. Fortunatly the screw worked nicely :cheers: THALL, :cheers: also thank you, I must have got caps built on a monday, when the screw just started to get tight the little tit on the H jet snapped right off, didnt even have to pull the cap out...

Dealer wont even leave it lying around after he finds $5 on the floor :monkey: If anyone has an extra 5910 890 4500A they'ed part with please let me know, New DP cover on a 440, waiting on a friends tach to check it. 13500 after a few cuts sound about right with an 18"?

Wanting to try this setup, Good/excellant condition prefered. Shoot me a PM. Thanks TB