Sold 064/066 Ported

[MillerModSaws]

ok boys I've been slowly putting this one together for awhile. And she is almost done. I have a couple little parts to put on her but thought I'd go ahead and post it. This saw has been rebuilt from the ground up. New crank bearings and seals, new rubbers, all new mounts and piston. One the port work I cut the base and squish to get the exhaust down where I wanted it and raised the transfers. Exhaust and intake are stock.
That said she's gonna be strong. It's a factory non decomp 066 cylinder. I did not advance the timing. I can but she's already a knuckle buster so I'll leave that up to the customer. $850 pho only shipped to the lower 48. PayPal F&F or add 4%.
Any questions just holar.

 

[MillerModSaws]

 

[MillerModSaws]

 

[MillerModSaws]

In the vid. I made 2 cuts to tune and the snapped a qwick vid. Once she gets broke in she's gonna be a good runner.

 

[MillerModSaws]

Bump

 

[MillerModSaws]

I would consider partial trades especially for a good pro top handle saw.

 

[Jeremiah]

Ugh so tempting

 

[MillerModSaws]

Bump. Would consider partial trades. Thanks guys.

 

[MillerModSaws]

Bump

 

[MillerModSaws]

Any trades out there. I got a few saws I'm needing.

7900 class saws, 395xp, 2188, 421, or hit me with what ya got.

 

[ashcutgood661cm]

Looks like my saw dawgs off my old 440