3120xp setup

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.

Sierradmax

ArboristSite Operative
Joined
Mar 18, 2013
Messages
297
Reaction score
322
Location
RI
What kind of sprocket would suit best for a 3120xp in a mill setup? From what I understand, it's not a high RPM saw but has alot of torque. Would the saw pull an 8 tooth fine on a 36" blade?
 
I run a 8 tooth 404 on both my 880 and 076 just fine. The bar length, Type of wood, chain size and how sharp the chain is, have a lot to do with this also.
 
I use a 7 tooth on a 42" bar. I feel its a little easier to run and easier on the saw than an 8. I mostly cut hardwoods, up to 30" or so. For smaller stuff and softer woods the 8 is faster.
 
Back
Top