Sold 372 x torq w full wrap & muff mod $550

[stevetheboatguy]

If you remember I had this posted a while ago. It didn't sell so I muff modded it. Put a full wrap and big dogs on, replaced the loose kill switch and now I found something else I want more than it.
So if anyone wants it for $550 and actual shipping, it's theirs. Or if you want the half wrap and small spikes $500. and actual shipping.

The muffler that was modded is a am. And the original goes with the saw as well.

I have only run about a half a tank since the muff mod. It tuned nicely and is noticeable more responsive and snapy.

Any questions just ask. I know this saw inside and out.




Steven

 

[BenK]

Man I want it!!

Gotta sell a kid or something GLWTS

 

[stevetheboatguy]

Bump/ update. About 5-6 tanks through it with the muff mod on it. Wish I would have modded it sooner!

Steven

 

[stevetheboatguy]

More info for you guys. The saw is a 2011 365 it was new old stock sold in 2014 to the guy I got it from. He used it and had the pto side bearing cage come apart. I bought it and did a total teardown and rebuild on it. I used high quality C3 bearing. (I will find the brand but I'm drawing a blank right now) new oem 372 replacement cylinder and piston. And a set of aftermarket crank seals and clutch cover.
I have been using the saw and it has been flawless. I have somewhat been keeping tabs on fuel used and it's getting close to 30 tanks on it now. It's kinda been my favorite saw to run for the last while. Especially wih the added wrap, big dogs and muff mod. But it's also the most oem and factory original saw I have right now. That's why it's up for sale and not the others. To much to sort through on them. This one is straight forward and ready to use.

Steven

 

[stevetheboatguy]

Put a new cover on the half wrap. And got new piston pic's. No change since last pic's.
My saw's are getting parked for a while. Looking like I'm going back to work early this year. Curse this warm weather!!



Steven

 

[BenK]

Still trying to sell my saw to fund this one! I'll keep you posted if I do.

 

[stevetheboatguy]

It's all good. I didn't run the vp into this one yet. I'm hoping I can get a chance to cut up some silver maple. Once I get that done I'm going to do the same to it and do the vp and clean it up.

Steven