ArboristSite.com Sponsors
 
 


atom ignition module, how to connect?

Discussion in 'Chainsaw' started by NWCS, Apr 28, 2005.

  1. NWCS

    NWCS Addicted to ArboristSite

    Joined:
    Apr 19, 2005
    Messages:
    1,233
    Likes Received:
    26
    Location:
    Poulsbo, WA
    hey all, found an old "atom computer ignition" module sitting in my toolbox ive had about 8 years.. i dont have the instructions anymore.. would like to try it on my Mcculloch SP125C. do these things really work? btw the module i have is Blue and has one blue wire and one white. thats all i know about it. no clue how they work.. i can understand points.. they open and close.. and go bad quite often (my bad luck :)
     
  2. stihltech

    stihltech Addicted to ArboristSite

    Joined:
    Mar 23, 2002
    Messages:
    2,396
    Likes Received:
    105
    Location:
    western NY
    atom

    Blue, not sure if it will work. Only used brown and orange. BUT, nothing ventured, nothing gained.
    One wire to ground, one wire to coil and switch. Make sure points and condensor are disconnected.
    If it does not seem to rev, switch wires.
     
  3. NWCS

    NWCS Addicted to ArboristSite

    Joined:
    Apr 19, 2005
    Messages:
    1,233
    Likes Received:
    26
    Location:
    Poulsbo, WA
    well i just got word from Atom, the blue module is incorrect, i need the brown one.. didnt cost me a thing so nothing is hurt.
     
  4. ozflea

    ozflea Good ol' BP Zoom 25-1

    Joined:
    Dec 9, 2004
    Messages:
    3,881
    Likes Received:
    341
    Location:
    NSW or is it QLD .. Australia
    Dedcow just one little point to the brown module it has an inbuilt rev limiter.

    Mc Bob
     

Share This Page