Husqvarna 350/346 mods

[werewolf]

installed a Easysaw 346 type cylinder on my 350, seems to be well made, I use everything from OEM to good aftermarket ones and this is good as the best but courious about setting my max rpm, I'm old school and do plug reads and can tune by sound but kinda wanna push this build, should I set around 13000 or push it up a little?

 

[HuskStihl]

Push it. Push it real good.

 

[werewolf]

Ha ha ha, I'm planning on it!

 

[Andrew Currans]

Did you ever fine tune your 350? I just finished mine yesterday. Not sure how high I'm spinning it because I don't have a tach but I know it's up there. Hopefully I don't cry the bottom end by over revving it but she cuts great lol

 

[werewolf]

I have it set at 13000, seems fine there at least until I get some hours on it, can bury my 18" bar in any of our hardwoods and not bog it at all, can even push on it a bit, my go to saw now over my modded 036! Weight being the factor there

 

[Allcl455]

I have a numpty question .if I swap the sprocket for one in 3/8 pitch and put a 3/8 pitch bar 20 inches long on it will my 350 be able to run it?

 

[grizz55chev]

What’s a numpty?

 

[werewolf]

I tried it and went with a LP chain, less cutters per the 3/8” but teeth like a .325, no opinion yet