Minimum squish clearance test

[mweba]

Did you notice any performance difference?

Yes it ran like @#^%


Edit

Sorry should clarify. Every time I dropped the jug, I did not adjust the port timing. Was not really interested in that aspect so it ran pourly. I could get it out of four stroke at 11900

 

[Stumpys Customs]

Yes it ran like @#^%

I ment before the last test.
How many tests did you run?

 

[mweba]

I ment before the last test.
How many tests did you run?

It ran ok at .014ish and sorry for thowing that edit in late. This vid is .015 I think.

<object width="640" height="385"><param name="movie" value="http://www.youtube.com/v/ZiqCunuE6GI?fs=1&amp;hl=en_US"></param><param name="allowFullScreen" value="true"></param><param name="allowscriptaccess" value="always"></param><embed src="http://www.youtube.com/v/ZiqCunuE6GI?fs=1&amp;hl=en_US" type="application/x-shockwave-flash" allowscriptaccess="always" allowfullscreen="true" width="640" height="385"></embed></object>

 

[parrisw]

Ha ya figured you would catch it. Funny enough I almost didn't before shaving the jug again and getting ready to assemble it. That would have been BAD.

Ya, run it like that and get a vid for us all to see, would be cool!! LOL

 

[mweba]

Ya, run it like that and get a vid for us all to see, would be cool!! LOL

Sorry, I will ship it up to ya if you want to give it a go! I already have the new top end on it.

I did four tests.

 

[Stumpys Customs]

Nice work MR, very informative.oke:

 

[parrisw]

Sorry, I will ship it up to ya if you want to give it a go! I already have the new top end on it.

I did four tests.

ha ha. I was kidding. Wouldn't want to chance a good saw! I don't have a 660 to test on anyway.