Oregon bar 17722 2050w0660tv

Arborist Forum

Help Support Arborist Forum:

This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Hello Jon1212 and thank you.
Yes the bar specs are what I'd like. I get its a 20 inch but the rest I cant seem to find out there.

Thanks again
Okay, if I'm reading this correctly, that bar comes up as being a hard nose bar, but is .050 in gauge, so you could potentially run 3/8 or 325 around it, as long as it is 050. As far as what it will fit, it is an A095 so it has a slightly narrower tail profile than a K095. This means it will fit a myriad of saws that typically use a K095(aka Husqvarna Small mount). What were you thinking of using this bar on?
 
Hey Jon

Thanks for the help. From these numbers I still cant decipher the drive links. I know it will be different for .325 or.375. Will run .375
cuz of the sprocket.

Thanks again
 
Back
Top