Welcome to ArboristSite.com! Log in or Sign up to interact with the ArboristSite community.

ArboristSite.com Sponsors
 
 


  1. Please see this post Click Here Please ask questions if you have them!! I hope this is going to be great for us all.
    Dismiss Notice

Poulan S6000 Guide bar

Discussion in 'Milling & Saw Mills' started by mel4638, Jan 4, 2017.

  1. mel4638

    mel4638 ArboristSite Lurker

    Joined:
    Jan 4, 2017
    Messages:
    6
    Likes Received:
    0
    Location:
    Cranbrook British Columbia Canada
    Hi , I have a Poulan S6000 which I think is a branded Dolmar 152 . I use it on a woodbug sawmill . I am looking for a chainsaw bar that is 37 1/8 in length , with a spocket tip , it is 404 pitch and .063 guage . The stud slot is 14 mm . Stamped on the bar is J63X 44067 1694 . I have 2 of these saws that were purchased new in the early 80s and have less than 20 hours on each of them . Both run like new but cannot find any bars to fit that saw in my area . Would apreciate any help in where I might purchase a bar that I mentioned earlier . Thank you .
     
  2. rarefish383

    rarefish383 Addicted to ArboristSite

    Joined:
    Nov 2, 2009
    Messages:
    3,182
    Likes Received:
    2,507
    Location:
    MD
    Go back to the menu and drop down till you see the "Chainsaw" forum, they are better at finding older parts. We can help you out with milling questions. A lot of the guys on the chainsaw forum collect the older Poulans and can probably hook you up, Joe.
     
  3. mel4638

    mel4638 ArboristSite Lurker

    Joined:
    Jan 4, 2017
    Messages:
    6
    Likes Received:
    0
    Location:
    Cranbrook British Columbia Canada
    Thank you
     
  4. sawfun

    sawfun Addicted to ArboristSite

    Joined:
    Jan 11, 2014
    Messages:
    1,969
    Likes Received:
    1,939
    A any bar for a Stihl 075, 088, 090 ms880 will work with minor oil hole modification. Stihl 3002 series or Cannon S2 I believe.
     
  5. mel4638

    mel4638 ArboristSite Lurker

    Joined:
    Jan 4, 2017
    Messages:
    6
    Likes Received:
    0
    Location:
    Cranbrook British Columbia Canada
    One more question , would anyone know the value of a Poulan S6000 ? I bought 2 of theses saws in the early 80s and one of the saws has from 1 to 8 hours on it . The saw looks and runs like new and I have the manual for it .The other saw I use on my chainsaw mill and will keep . The saw that looks new the only thing wrong is the poulan decal was rubbed from moving it around my garage for 35+ years .
     

Share This Page