Stihl 019T oil pump
- Thread starter Tdkclydes
- Start date
Help Support Arborist Forum:
I think you have to remove the motor to get it out. I had one and had to remove the motor to do just about anything to it.
If you ask in teh beg for manulas thread someone will most likely send you an IPL if you post there.
Make sure the drive rod is wroking to the oil pump that is driven off the sprocket.
If you ask in teh beg for manulas thread someone will most likely send you an IPL if you post there.
Make sure the drive rod is wroking to the oil pump that is driven off the sprocket.
IT hit me today while out cutting on my 019T it quit oiling and I found after removing the clutch that the rod that drive the oil pump had worn away and the bushing drive worm gear that the rod was attached to actaully kind of split. So all I ad to do was replace the worm drive which I think came with a rod on it when ordered from the dealer.
Remove the clutch and see first what is going behind that before going any further on it.
Remove the clutch and see first what is going behind that before going any further on it.
