woods port saw video thread

[huskyboy]

Very first cuts in wood after new meteor piston. Mdavlee ported. Ignore the clothing I relaxed my safety standards as I was cutting on a stationary log. It clobbered a stock in 394 with same 20" bar chain 7 pin sprocket by 4 secs in that log, and it ain't broke in.

 

[redbull660]

tree monkeyed 661

.404 8pin semi skip square...

 

[jmssaws]

 

[redbull660]

 

[redbull660]

 

[Imprzed205]

Jason Hope it didn't blow up like your other saws???

You cross me as someone that starts s**t to get a response. Or like one of the small ankle biting dogs that when when go to kick it tucks its tale and hauls ass. Lol

 

[Edwad]

You cross me as someone that starts s**t to get a response. Or like one of the small ankle biting dogs that when when go to kick it tucks its tale and hauls ass. Lol

Exactly. And I cant describe what you are. Lol

 

[Edwad]

You cross me as someone that starts s**t to get a response. Or like one of the small ankle biting dogs that when when go to kick it tucks its tale and hauls ass. Lol

You remind me of that small dog to. Little balls and a squeaky little bark. lol

 

[Imprzed205]

 

[Edwad]

View attachment 580589

That's really good.lol

 

[bikemike]

Bearing went out and booger'd this cylinder up,I had to raise the exhaust higher than I've ever had one but it was junk unless I did. Doesn't act to bad

Thunk it help raise the power band on it. Sounds great up at those rpm

 

[jmssaws]

Thunk it help raise the power band on it. Sounds great up at those rpm

I'm going to sell that cylinder.
It runs good and will make a good 28-32" saw

 

[bikemike]

I'm going to sell that cylinder.
It runs good and will make a good 28-32" saw

Think it has potential for a race jug too. Loves the rpm. Is there fingers? Bet it would be wild on alky

 

[jmssaws]

Think it has potential for a race jug too. Loves the rpm. Is there fingers? Bet it would be wild on alky

No fingers.
I have only made a few cuts with it then took it off.
It's not a super high exhaust
96 with 200-210lbs

 

[Armbru84]

Looks good!

 

[bikemike]

No fingers.
I have only made a few cuts with it then took it off.
It's not a super high exhaust
96 with 200-210lbs

**** grind some fingers and test it again then maybe build a pipe to fit jug and saw test and sell as a not piltz race saw kit. Hot husky and j red parts are always wanted in the northern states

 

[jmssaws]

**** grind some fingers and test it again then maybe build a pipe to fit jug and saw test and sell as a not piltz race saw kit. Hot husky and j red parts are always wanted in the northern states

Ive spent a lot of time messing with finger ports and found absolutely nothing.
I think if it gains from them your transfers were off.
They flow enough for most applications

 

[bikemike]

Ive spent a lot of time messing with finger ports and found absolutely nothing.
I think if it gains from them your transfers were off.
They flow enough for most applications View attachment 580621

Nice work

 

[jmssaws]

Nice work

I couldn't get them to do anything in a work saw,I don't know much about a pipe saw.
This is the 96 cylinder

 

[crabby cooter]

real work saws go to work, not sit on the shelf.