Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
026 spitting gas out of carb
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="fossil" data-source="post: 3583516" data-attributes="member: 76383"><p>Impulse line is OK . Holds 10 psi no leaks. Compression >160 psi. Piston looks good and clean.</p><p></p><p>The metering gasket / diaphram assembled with gasket against the carb body then the diaphram and then the cover.</p><p></p><p>On the fuel pump side there is a gasket against the cover and a tan colored mylar diaphram????? There is no fibre washer under the screw head.</p><p></p><p>I will upload a few pics in a bit.</p><p></p><p>I did have the air filter off when it was spitting gas.</p></blockquote><p></p>
[QUOTE="fossil, post: 3583516, member: 76383"] Impulse line is OK . Holds 10 psi no leaks. Compression >160 psi. Piston looks good and clean. The metering gasket / diaphram assembled with gasket against the carb body then the diaphram and then the cover. On the fuel pump side there is a gasket against the cover and a tan colored mylar diaphram????? There is no fibre washer under the screw head. I will upload a few pics in a bit. I did have the air filter off when it was spitting gas. [/QUOTE]
Insert quotes…
Verification
Post reply
Top