Sold 051AV Stihl

[singinwoodwackr]

This is a parts saw, not a runner.
P&c look "ok" via bore scope. Missing one dog; air filter is trash; been sitting for some time according to the owner. Handle is broken at the joint. Damage to starter cover.

Looking for $200 shipped to the lower 48, OBO

 

[singinwoodwackr]

Bore scope

 

[singinwoodwackr]

The saw came in for evaluation and I just don't have any experience with this series so suggested selling it as is.

 

[Lightning Performance]

Looks decent.
The oil pump assembly gets people frustrated sometimes. Three different drum drive setups for the pumps. Always wonder if a bigger jug could fit on the deck. These have some grunt being 85cc small bore with a 42mm crank and closely setup like 075, 076 and TS760. I have the 760s.
Parts are out there. AM supports these.
In decent shape at glance.
Glws

 

[MFV]

Looks decent.
The oil pump assembly gets people frustrated sometimes. Three different drum drive setups for the pumps. Always wonder if a bigger jug could fit on the deck. These have some grunt being 85cc small bore with a 42mm crank and closely setup like 075, 076 and TS760. I have the 760s.
Parts are out there. AM supports these.
In decent shape at glance.
Glws

Who is AM that support these?

 

[Lightning Performance]

@MFV
HLS, LRB and a few others.
Pistons are out there. Check on seals or an alternative. AM supports the pto side. Swapping with 075/076 and the TS760. Check them all to be sure. This has a smaller bore compared to it's big brothers. 050 is the early parts.

 

[bulletpruf]

@MFV
HLS, LRB and a few others.
Pistons are out there. Check on seals or an alternative. AM supports the pto side. Swapping with 075/076 and the TS760. Check them all to be sure. This has a smaller bore compared to it's big brothers. 050 is the early parts.

You can swap the larger jug/piston from an 075/075, but the larger jugs take studs not bolts and the thread size is one larger, IIRC.

PM sent...

 

[Lightning Performance]

You can swap the larger jug/piston from an 075/075, but the larger jugs take studs not bolts and the thread size is one larger, IIRC.

Seems manageable. I have two 760s here apart. Both are smoked bad. The jugs are trash and one crank is done for.