Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
1-40 McCulloch Chainsaw Manual Oil Pump rubber seal(not o-ring) needed.
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="heimannm" data-source="post: 7795249" data-attributes="member: 8552"><p>The 1-40 would not have had a manual oiler from the factory, they relied on the "Lubri-Mac" system that scavenged "unburned fuel and crankcase residue" and directed it toward the bar pad.</p><p></p><p>Yours might have the later add on oil tank on the front of the saw, I am not sure I have ever seen a parts breakdown for one of those.</p><p></p><p>Mark</p></blockquote><p></p>
[QUOTE="heimannm, post: 7795249, member: 8552"] The 1-40 would not have had a manual oiler from the factory, they relied on the "Lubri-Mac" system that scavenged "unburned fuel and crankcase residue" and directed it toward the bar pad. Yours might have the later add on oil tank on the front of the saw, I am not sure I have ever seen a parts breakdown for one of those. Mark [/QUOTE]
Insert quotes…
Verification
Post reply
Top