Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Firewood, Heating and Wood Burning Equipment
36 inch bar on a CS-2166?
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Trapper_Pete" data-source="post: 6767527" data-attributes="member: 146897"><p>Well I ended up ordering a 28 inch bar , it keeps withing what the manufacturer recommends for the saw even if it is the top end , I am going to try the 28 with skip chain and see how I like it my dealer keeps 3/8 .058 skip and full comp in stock so it seemed like a good way to go.</p><p></p><p>I went out and measured the tree I did Wednesday it was right at 29 the next 2 big trees are about 33 and about 37 both oak.</p><p></p><p>so I wasn't getting all the way across with this saw , but with the 28 and some technique and careful planning of the notch and back cut it should be better and not too much for the saw.</p></blockquote><p></p>
[QUOTE="Trapper_Pete, post: 6767527, member: 146897"] Well I ended up ordering a 28 inch bar , it keeps withing what the manufacturer recommends for the saw even if it is the top end , I am going to try the 28 with skip chain and see how I like it my dealer keeps 3/8 .058 skip and full comp in stock so it seemed like a good way to go. I went out and measured the tree I did Wednesday it was right at 29 the next 2 big trees are about 33 and about 37 both oak. so I wasn't getting all the way across with this saw , but with the 28 and some technique and careful planning of the notch and back cut it should be better and not too much for the saw. [/QUOTE]
Insert quotes…
Verification
Post reply
Top