Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Cheap way to stand up the new chain grinder???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Jeff Lary" data-source="post: 4154916" data-attributes="member: 75915"><p>One way we used to mout bench style grinders was to take a tire rim (15" and above) weld an iron pipe in the center hole then a steel plate on top of the iron pipe. Then you mount your grinder to the steel plate. Then whenever you want to move it in the shop just tip it towards you and roll it like you would a barrel.</p></blockquote><p></p>
[QUOTE="Jeff Lary, post: 4154916, member: 75915"] One way we used to mout bench style grinders was to take a tire rim (15" and above) weld an iron pipe in the center hole then a steel plate on top of the iron pipe. Then you mount your grinder to the steel plate. Then whenever you want to move it in the shop just tip it towards you and roll it like you would a barrel. [/QUOTE]
Insert quotes…
Verification
Post reply
Top