Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
CSMilling with 390xp and 42" Bar???
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Andyshine77" data-source="post: 6816393" data-attributes="member: 4158"><p>Opening up the muffler would be a really good idea to keep the engine tips down as much as possible. Also you're going to want to richen up the high-speed jet on that carburetor, almost to the point where it for strokes even when cutting. And run 32:1 fuel mix. A 42"bar is more than that saw wants, but if it's not an everyday all day type of thing and you take a few precautions, the saw will be fine.</p></blockquote><p></p>
[QUOTE="Andyshine77, post: 6816393, member: 4158"] Opening up the muffler would be a really good idea to keep the engine tips down as much as possible. Also you're going to want to richen up the high-speed jet on that carburetor, almost to the point where it for strokes even when cutting. And run 32:1 fuel mix. A 42"bar is more than that saw wants, but if it's not an everyday all day type of thing and you take a few precautions, the saw will be fine. [/QUOTE]
Insert quotes…
Verification
Post reply
Top