Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Hand Held Equipment and Tools
Flywheel bore taper angle
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Kebo57" data-source="post: 7982833" data-attributes="member: 172019"><p>Hi I’ve got 45 hedge cutter in that’s been messed about with it’s got a Chinese crank with keyway for the flywheel in the wrong place so timing is out, keyway is sheered off the flywheel it runs well with the flywheel set correctly at Tdc, I’ve got a 2mm push type keyway broach coming to recut the keyway in the correct place, I’ll need to make a guide bush for the broach so does anyone know the angle in the bore of the 45 flywheel</p><p>Any help would be greatly appreciated</p><p>PS I have the slotting head on my mill and have cut keyways on lathe.</p></blockquote><p></p>
[QUOTE="Kebo57, post: 7982833, member: 172019"] Hi I’ve got 45 hedge cutter in that’s been messed about with it’s got a Chinese crank with keyway for the flywheel in the wrong place so timing is out, keyway is sheered off the flywheel it runs well with the flywheel set correctly at Tdc, I’ve got a 2mm push type keyway broach coming to recut the keyway in the correct place, I’ll need to make a guide bush for the broach so does anyone know the angle in the bore of the 45 flywheel Any help would be greatly appreciated PS I have the slotting head on my mill and have cut keyways on lathe. [/QUOTE]
Insert quotes…
Verification
Post reply
Top