Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Tree Care Forums
Milling & Saw Mills
Gas Consumption Question On 1 Cut Or Pass
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="Mad Professor" data-source="post: 960076" data-attributes="member: 16108"><p>I can get a few cuts with my 066 on a logosol mill on one tank. I'm running stihl pmx chain and the cuts are with a buried 16-24 " bar in hardwood (ash hard maple oak). With white pine I can get quite a few cuts.........</p><p></p><p>P.S. pmx chain is stihl picco (e.g. 3/8 low profile) ground to 5-10 degrees, less kerf = less gas</p></blockquote><p></p>
[QUOTE="Mad Professor, post: 960076, member: 16108"] I can get a few cuts with my 066 on a logosol mill on one tank. I'm running stihl pmx chain and the cuts are with a buried 16-24 " bar in hardwood (ash hard maple oak). With white pine I can get quite a few cuts......... P.S. pmx chain is stihl picco (e.g. 3/8 low profile) ground to 5-10 degrees, less kerf = less gas [/QUOTE]
Insert quotes…
Verification
Post reply
Top