Sold Husqvarna 550xp

[husqvarnaxpman]

550xp. 2015 model and it does have the bog off from idle sometimes. I haven't tried adjusting the hidden screw. When I got the saw it had been ran over. Replaced handle, tank and recoil with good used parts. I took the saw to the local dealer and it only had a little over 2.5 hours on it. Piston looks good. It does have some battle wounds from getting ran over but nothing broke that I am aware of. I have put about 1 tank through it. Would like to trade it for a 353 or a 346 parts saw as long as it is in decent shape or a running saw with money on my end if needed. Selling price would probably be $275

 

[ammoaddict]

It looks pretty good to have been run over. If I didn't have a 545, I would be very interested. The 545 is a 2017 model and it has the bog off idle sometimes as well. It's more of a slight hesitation than a bog and it doesn't do it all the time. I have a couple small saws I need to sell. If I can sell them before you sell this, I might still be interested.

Sent from my moto g(7) power using Tapatalk

 

[cuinrearview]

Tempting.

 

[ammoaddict]

Tempting.

You might as well buy it. You know somebody is going to. If I had the extra money I would buy it for my church volunteer group.

Sent from my moto g(7) power using Tapatalk

 

[cuinrearview]

You might as well buy it. You know somebody is going to. If I had the extra money I would buy it for my church volunteer group.

Sent from my moto g(7) power using Tapatalk

The XP man is five minutes from me too. You'd think he'd give a guy a head's up...

 

[cuinrearview]

I'm going to bed. When I pop on here in the morning if this is still here I'll make my move. Y'all been warned.

 

[husqvarnaxpman]

The XP man is five minutes from me too. You'd think he'd give a guy a head's up...

Sorry man, didn't figure you would be interested.

 

[husqvarnaxpman]

You got anything to trade?

 

[Matt Schmitt]

Last 15 I had cost around 125 for a carb I believe. I had the xpg not sure if it was more.

 

[LogSawyer74]

I've got a pretty clean 351 I bought a few months ago. Ran fine when I bought it. Soon afterwards, I bought a ne 346xp top end kit. I disassembled the 351 to convert to 346 and that's where we currently sit. I've got the entire 351 (disassembled) and a new OEM 346 top end I can ship you. Interested?

 

[LogSawyer74]

I just remembered something about the 351 I should have included. It's leaks bar oil. More than a few drips. Not from case gasket, from oil pump area. Will leak an entire tank of oil in a few weeks. Never looked into it, probably needs new oil line.