Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
Issues after work-over on Makita 6401
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="huskydave" data-source="post: 858934" data-attributes="member: 14396"><p>The compression will go up about 9-10psi after breakin. If you have a new piston and cyl you should have more compression unless your compression tester calved. How hard is it to pull? You should put a little 10w30 in the cyl before starting it.</p></blockquote><p></p>
[QUOTE="huskydave, post: 858934, member: 14396"] The compression will go up about 9-10psi after breakin. If you have a new piston and cyl you should have more compression unless your compression tester calved. How hard is it to pull? You should put a little 10w30 in the cyl before starting it. [/QUOTE]
Insert quotes…
Verification
Post reply
Top