Menu
Forums
New posts
Search forums
Terms and Rules
What's new
New posts
New media
New media comments
Latest activity
Media
New media
New comments
Search media
Log in
Register
What's new
Search
Search
Search titles only
By:
New posts
Search forums
Terms and Rules
Menu
Log in
Register
Install the app
Install
Forums
Equipment Forums
Chainsaw
MillerModSaws Stares Down the 7310/7910
JavaScript is disabled. For a better experience, please enable JavaScript in your browser before proceeding.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an
alternative browser
.
Reply to thread
Help Support Arborist Forum:
This site may earn a commission from merchant affiliate links, including eBay, Amazon, and others.
Message
<blockquote data-quote="MillerModSaws" data-source="post: 5533240" data-attributes="member: 96461"><p>UNLIMITED COIL. Well here's my thought. This makes the saw so much easier to tune it's not funny. In the vid that saw is still running really rich. However if your cutting in hard wood all the time you can absolutely get bye without this mod. My last cuts where in maple and this mod was really nice cause the saw was running about 13300 in the cut with light pressure so it would have been bouncing off the rev limiter if this mod wasn't done. Or you would have had to just simply push on the saw a bit harder. Lol.</p></blockquote><p></p>
[QUOTE="MillerModSaws, post: 5533240, member: 96461"] UNLIMITED COIL. Well here's my thought. This makes the saw so much easier to tune it's not funny. In the vid that saw is still running really rich. However if your cutting in hard wood all the time you can absolutely get bye without this mod. My last cuts where in maple and this mod was really nice cause the saw was running about 13300 in the cut with light pressure so it would have been bouncing off the rev limiter if this mod wasn't done. Or you would have had to just simply push on the saw a bit harder. Lol. [/QUOTE]
Insert quotes…
Verification
Post reply
Top